Ultraflux Uf 841, User Manual

Page: 18 / 105

18
NT UF 841 CP GB (d) / June 2015
3.1 General
Before any operation on the unit, the user instructions NT300, supplied with the unit, must be read.
The Uf 841 casing presents no particular danger to the user. Depending on the environment where the unit
is installed, it is however recommended to wear personal protective equipment during assembly, including:
gloves, safety boots, impact goggles.
It is recommended to follow the assembly method described below in order to avoid all risk of injury.
Assembly must be carried out or inspected by Ultraflux to ensure the unit is leakproof and will operate
correctly.
Important: Avoid installing the Uf 841 close to a frequency converter. If this cannot be avoided,
interference filters must be installed. It is highly recommended to contact us if this situation arises.
It is also recommended to separate the paths of the measurement cables and the power cables.
3.2 Attachment
The unit's mounting plate is multi-support and may be attached to piping, to a horizontal surface or to a
vertical surface as shown in the illustrations below:
Assembly on piping
Assembly on a horizontal surface
Assembly on a vertical surface