Page 29
4.3
Displayed Error Messages / Symbols
The failures are divided into two categories
.
a.
Failure that occur before completing the sterilization stage, which in
this case will leave the load unsterilized
b.
Failure that occur after completing the sterilization stage, which in this
case will leave the load sterilized
For the list of
Displayed
Error Messages / Symbols
see sec. 12.
4.4
Displayed operational messages / Symbols
Message /
Symbol Name
Message /
Symbol
Description
Required Action
This symbol is displayed when
the door is open.
Close the door.
Door is open
(during stand by)
This message is displayed
when the door is opened: In
standby - if
START/STOP
is
preset.
Close the door to
perform a new cycle.
Cycle Ended
This message is displayed
when the cycle ended
successfully.
Press
START/STOP
to
perform a new cycle.
Test Ended
This message is displayed
when the test ended.
Press
START/STOP
to
perform a new test
This symbol is displayed when
Cycle by Clock mode is
performed.
Enter the Admin menu
as described in this
manual to change the
time or to cancel this
option.
Cycle by clock
This message is displayed if
the user presses
START/STOP
key while the
"cycle by clock" mode is
active.
Enter the Admin menu
as described in this
manual to change the
time or to cancel this
option.
Atmospheric
pressure not set
This message id displayed to
set the atmosphere pressure
by opening the door for 5
minutes.
Open the door for 5
minutes to set the
Atmospheric pressure.
Summary of Contents for LabSci 11-V
