Page 90
12.
Troubleshooting
This troubleshooting chart enables the user to solve minor
malfunctions, prior to contacting our service department.
Only technical personnel having proper qualifications and
holding technical documentation (including a technician manual)
and adequate information are authorized to service the
apparatus.
Message /
Symbol /
Problem
Failure Description
Corrective Action
The machine
is not
responding
1
The main switch is in
‘OFF’ position.
2
The power cord is
disconnected from the
machine or the mains.
3
The circuit breaker
has tripped.
1
Turn the main
switch
to the ‘On’
position.
(see front view
drawing).
2
Make sure the
power cord is connected
properly to the machine
and the mains.
(see rear view
drawing)
3
Lift the circuit
breaker lever.
The printer
prints, but
nothing is
printed on
the paper.
1
The Paper roll is not
installed in the right way.
(see sec. 8.2, Printer
handling)
1
Install the paper
roll in the right way.
Only one side of the
paper is printable.
(see sec. 8.2,
Printer handling)
The printer
does not
print.
1
No paper is inserted in
the printer.
(see sec. 8.2, Printer
handling)
2
No obvious reason.
1
Make sure the
paper roll
is inserted in the printer.
(see sec. 8.2, Printer
handling)
2
Switch off the
machine and switch it
back on for restart
The machine
is leaking at
the door
1
The door gasket is
dirty.
(see sec. 11.1.1, daily
maintenance)
2
The door gasket is
1
Clean the door
gasket.
(see sec. 11.1.1, daily
maintenance).
2
call for service.
Summary of Contents for LabSci 11-V
