9
TM
85809
SETUP AND ASSEMBLY
HOPPER DEFLECTORS
MANUAL
TUBE
1/4" x 5/8" HEX
HEAD SCREWS
1/4"
NUTS
1/4" NUTS
FIGURE 3
HOPPER ASSEMBLY
AS85809-02
FRONT OF
TOP
DRESSER
● Attach the panels with a 1/4” x 5/8” long hex head
Whiz-Lock screw at each top corner (Quantity 4),
and 1/4” x 5/8” long hex head Whiz-Lock screws
and nuts down each corner (Quantity 16).
● Insert screws from the inside and place nuts on the
outside.
DO NOT TIGHTEN SCREWS AT THIS
TIME.
HOPPER DEFLECTORS AND MANUAL TUBE
INSTALLATION
(See Figure 3)
Step 5.
Insert a hopper deflector into the slots on the
top of the REAR hopper panel.
● Secure the deflector to the rear hopper panel using
1/4” x 5/8” hex head Whiz-Lock screws and nuts.
Tighten screws securely.
Step 6.
Insert a hopper deflector into the slots on the
top of the FRONT hopper panel.
● Secure the deflector and manual tube to the front
hopper panel using 1/4” x 5/8” hex head Whiz-
Lock screws and nuts.
● Use the two middle screws to fasten the manual
tube to the outside of the hopper. Tighten screws
securely.
Step 2.
Attach the side hopper seals to the outside of
the side hopper panels (panel top folded edge points
towards the inside).
● Use only the lower row of holes on the seals and the
panels.
● Face the black side of seal up towards the inside of
the hopper.
● Start at the front of the panel and work to the rear. An
extra length of seal will extend out the rear of the
panel.
● Use 1/4” x 5/8” long hex head Whiz-Lock screws and
nuts (Quantity 18). Tighten screws securely.
Step 3.
Install a 1/4” clip nut to each top corner of the
side panels. (Quantity 4)
Step 4.
Assemble the front and rear panels to the side
panels.
● The flanges on the front and rear panels should be
outside of the ends of the side panels.
● The ends of the front seal should be over the front
ends of the side seals.
