TM
26
85809
Three Position ON/OFF Switch:
Down Position - OFF
● All spreader functions stopped
● Returns engine to Idle
Middle position - Spinner ON, Conveyor OFF
● Brings engine to full throttle
● Starts spinners (speed setting and display will go to the last setting used)
Top Position - Spinner ON, Conveyor Belt ON
● Starts conveyor belt (speed setting and display will go to the last speed used)
Spinner Speed and Conveyor Speed Switches:
If lockout “L” shows in display, Spinner & Conveyor speed switches will not change preset speeds .
See “Yellow Lockout Button” instructions.
Spinner speed switch
● Changes the speed that the spinner is operating at in increments of 5%.
● Press up to increase speed or down to decrease.
Conveyor Belt speed switch
● Changes the speed that the conveyor belt is operating at in increments of 5%.
● Press up to increase speed or down to decrease.
OPERATION
L=
PRESET SPEEDS
A
B
C
®
TURFCO
SPINNER AND
BELT READOUT
DISPLAY
CONVEYOR BELT SPEED SWITCH
SPINNER SPEED SWITCH
THREE
POSITION
ON/OFF
SWITCH
GREEN PRESET
BELT AND SPINNER
SPEED SELECTION
BUTTONS
YELLOW LOCKOUT
BUTTON TO
CHANGE
PRESET SPEEDS
OP85809-11
FIGURE 18
85% AL 85%
DISPLAYS PRESET SELECTED “A” “B” OR “C”
NO LETTER WHEN SPEEDS ARE
MANUALLY CHANGED
DISPLAYS “L” WHEN PRESET SPEED IS LOCKED,
NO “L” WHEN UNLOCKED
DISPLAYS
CONVEYOR BELT SPEED PERCENTAGE
“0%” TO “100%”
DISPLAYS
SPINNER SPEED PERCENTAGE
“0%” TO “100%”
OP85809-10
FIGURE 19
Operating Electronic Control Box
(See Figures 18 and 19)
NOTE: Engine Must Be Warmed Up Before
Automatic Throttle Control Will Operate.
