Triumph 2010 Tiger 800, Service Manual

Page: 486 / 508

Electrical
Starter Motor
Removal
1. Remove the rider's seat <see page
16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the fuel tan k <see page
10-91).
4. Remove the airbox <see page
10-98).
5. Remove the throttle bodies (see page
10-107>.
6. Disconnect the low oil pressure warning light switch.
Z
Ease the boot from the starter cable terminal and
then release the cable bolt.
8. Detach the cable.
9. Release the fixings securing the starter motor to the
crankcase.
1. Starter motor
2. Starter cable fixing
3. Fixings
10. Ease the starter motor from the upper crankcase.
Inspection
1. Ensure the starter turns freely and without binding.
2. Check the starter 0-ring for damage and
deterioration. Replace as necessary.
Installation
1. Lubricate the starter motor 0-ring with a small
amount of petroleum jelly
2. Fit the starter motor to the upper crankcase ensuring
that the 0-ring does not become damaged during
installation.
3. Fit and tighten the starter bolts to
10 Nm.
4.
Refit the starter cable and secure with the bolt.
Tighten to 3 Nm.
5. Refit the starter cable boot.
6.
Connect the low oil pressure warning light switch.
Z
Refit the throttle bodies (see page
10-101).
8. Refit the airbox (see page
10-101
9. Refit the fuel tank <see page
10-92).
10. Reconnect the battery, positive (red) lead first.
1 1. Refit the rider's seat <see page
16- 13).
1 7.18
SeNice Manual
-
Tiger 800 and Tiger 800XC