Triumph 2010 Tiger 800, Service Manual

Page: 282 / 508

Fuel System/Engine Management
Ignition Switch and Immobiliser
Antenna
Note:
•
The immobiliser antenna is integral to the
ignition switch and cannot be serviced
separately.
Removal
1. Remove the rider's seat <see page 16-13>.
2. Disconnect the battery, negative (black> lead first.
3. Remove the fuel tank (see page 10-91).
4. Remove the two screws and remove the ignition
switch cover.
5. Without damaging the ignition switch and using a
suitable drill, carefully drill out the head of the shear
bolts securing the ignition switch to the frame.
1. Ignition switch and immobiliser antenna
2. Shear bolts
6.
Disconnect the ignition switch multiplug.
Z Noting the harness routing, remove ignition switch.
8. Remove the remainder of the shear bolt from the
frame.
Installation
1. Installation is the reverse of removal, noting the
following:
•
Install new shear bolts and tighten until the
heads shear off.
Throttle Cable
Adjustment
Note:
• Minor adjustments to the opening cable can
be made using the adjuster near the throttle
grip end of the throttle. Where a correct
setting cannot be achieved this way, the
adjusters at the throttle end of both cables
must be used. The opening cable must be
set first followed by the closing cable.
1. Throttle grip
2. Correct setting, 2-3 mm
1.
Remove the rider's seat (see page 16-13>.
2.
Disconnect the battery, negative (black> lead first.
3.
Set the 'opening' cable adjuster at the throttle grip
end such that it has an equal amount of adjustment
in each direction. nghten the locknut.
4. Remove the fuel tank (see page 10-91>.
10.104
SeNice Manual
-
Tiger 800 and Tiger 800XC