Triumph 2010 Tiger 800, Service Manual

Page: 76 / 508

Cylinder Head
5. Remove the spring.
cfhp
1. Spring
6. While holding the resister ring in place, pour out the
engine oil into a suitable container.
Z Ensure the resister ring is correctly located as shown
in the illustration below.
cfho
1.
Resister ring
8. Refit the spring.
9.
Hold the resister ends together and push the plunger
through the resister ring until the groove for the
snap ring aligns with the snap ring.
cfei_2
1. Resister ring
2. Plunger
3. Groove for snap ring
4.
Snap ring
10. When the groove aligns with the snap ring, release
the resister ring and move one end of the snap ring
into the groove. Slowly release the plunger to ensure
that it is held in place.
cfej
J
1. Groove for snap ring
2. Snap ring
1 1. Fit a new 0-ring and gasket to the hydraulic
tension er.
12. Fit the tensioner to the cylinder head as noted for
removal. Tighten the bolts to
9 Nm.
13. Remove the camshaft drive chain tensioner blade
wedge, taking care not to move or damage the
tensioner blade.
14. To release the hydraulic tensioner, rotate the
crankshaft 114 of a turn anti-clockwise using the bolt
fitted to the end of the crankshaft. Then rotate the
crankshaft clockwise until the 'dot' mark on the
primary gear aligns with the line at the bottom of the
cover.
3.1 0
SeNice Manual
-
Tiger 800 and Tiger 800XC