Trinnov Audio ALTITUDE 16, User Manual

Page: 151 / 164

151
Altitude
16
_ USER MANUAL
Once the master output level is set (see previous step), the Altitude
16
’s crossover calibration tool will automatically
set up the level, delay and polarity of each driver.
Before calibration, please note:
• The calibration procedure has to be done individually for each speaker;
• An MLS signal is sent to each driver of the selected speaker when the Calibrate button is selected;
• At the end of the calibration process, a warning message states that a new calibration of entire system is re-
quired.
Figure 133: Performing the calibration of the active crossovers
Remain in the Setup/ActiveXovers page of the Advanced Settings interface to perform the calibration of the active
crossovers:
• If two or more speakers are linked, please unlink them by turning off the Link button.
• Follow the microphone placement instructions (see previous chapter).
• Make sure the measurement environment is silent.
• Press the Mute button to cut the outputs (this step must ALWAYS be performed before pressing on the Cali-
brate button)
• Press the Calibrate button in the Setup/ActiveXovers page of the Advanced Settings interface
• Follow the on-screen instructions regarding the microphone.