Toshiba e-studio205L, Service Handbook, Page: 498 / 672

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 94
[CC80] Alignment motor (front) abnormality
MJ-1025 (Alignment motor (front) abnormality)
Is the aligning plate home position sensor (front) (PI4) working properly?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and alignment motor (front) (M4)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
YES Fix the mechanism.
NO
Try replacing the alignment motor (front) (M4). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
MJ-1024 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
NO Fix the mechanism.
YES
1. Replace the front aligning plate motor.
2. Replace the finisher controller PC board.
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the rear alignment plate is moved?
YES Fix the mechanism.
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the rear alignment motor (M10).
2. Replace the finisher control PC board.