Toshiba e-studio205L, Service Handbook, Page: 493 / 672

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 89
[CC30] Paddle motor abnormality
MJ-1025
[CC30] Stack processing motor abnormality
Is the wiring between the finisher controller PC board and the saddle stitcher controller PC
board connected?
NO Connect the wiring.
YES
1. Replace the finisher controller PC board.
2. Replace the saddle stitcher controller PC board.
Is the paddle home position sensor (PI2) working properly?
NO Replace the sensor.
YES
Is the swing guide home position sensor (PI3) working properly?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and paddle motor (M2) correct?
NO Correct the wiring.
YES
Try turning the paddle motor counterclockwise by hand. Is there mechanical trapping in the
up/down movement of the swing guide?
YES Fix the mechanism.
NO
Try replacing the paddle motor. Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
MJ-1031
1. Check if the connector J111 on the finisher controller PC board is disconnected from the
stack edging HP sensor (SR8) or the harnesses are open circuited. Correct if any.
2. Check if the connector J111 on the finisher controller PC board is disconnected from the
stack slide motor (M4) or the harnesses are open circuited. Correct if any.
3. Replace the stack edging HP sensor.
4. Replace the stack slide motor.
5. Replace the finisher control PC board.
* You receive a [CC30] error when the [EA70] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the stack transport belt is moved?
YES Fix the mechanism.
NO
Is the harness between the stack transport motor (M5) and the finisher control PC board
(CN10) disconnected or open circuited?
l YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the stack transport motor (M5).
2. Replace the finisher control PC board.