Toshiba e-studio205L, Service Handbook, Page: 445 / 672

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 41
[E160] PFP lower drawer misfeeding (paper not reaching the PFP lower drawer feed sensor)
Is the PFP upper drawer feed clutch working?
(Perform the output check in the test mode: 03-226)
l
l
l
l
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the PFP upper drawer feed clutch is
disconnected.
2. Check if any of the connectors CN241 and CN247 on the PFP board
is disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the connector pins are disconnected and the harnesses are
open circuited.
5. Check if the conductor patterns on the PFP board and LGC board
are short circuited or open circuited.
6. Replace the PFP upper drawer feed clutch.
7. Replace the PFP board.
8. Replace the LGC board.
YES
Check the PFP upper drawer feed roller, separation roller and pickup roller.
Replace them if they are worn out.
Open the PFP side cover. Is there any paper in front of the PFP lower drawer feed sensor?
YES Remove the paper.
NO
Is the PFP lower drawer feed sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[3]/[B])
l
l
l
l
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the PFP lower drawer feed sensor is
disconnected.
2. Check if either of the connectors CN241 or CN243 on the PFP board
is disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the connector pins are disconnected and the harnesses are
open circuited.
5. Check if the conductor patterns on the PFP board and LGC board
are short circuited or open circuited.
6. Replace the PFP lower drawer feed sensor.
7. Replace the PFP board.
8. Replace the LGC board.
YES