Toshiba e-studio205L, Service Handbook, Page: 489 / 672

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 85
[CB60] Stapler unit shift motor abnormality
MJ-1025
Is the slide home position sensor (PI18) working properly?
NO Replace the sensor controller PC board.
YES
Is the wiring between the finisher controller PC board and slide motor correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the stapler stand motion path?
YES Fix the mechanism.
NO
Try replacing the slide motor (M8). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
MJ-1024
Is the stapler shift home position sensor (PI40) working normally?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the stapler shift motor (M35)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the stapler stand motion path?
YES Fix the lift mechanism.
NO
1. Replace the stapler shift motor.
2. Replace the finisher controller PC board.
MJ-1101
Is there any mechanical problem when the stapler is moved?
YES Fix the mechanism.
NO
Is the harness between the stapler unit shift motor (M4) and the finisher control PC board
(CN5) disconnected or open circuited?
l YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the stapler unit shift motor (M4).
2. Replace the finisher control PC board.