Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 53 / 72

Replacing and Tensioning the
Alternator Belt
Replacing the Alternator Belt
Service Interval: Every 50 hours—Check the alternator belt.
If the alternator belt needs to be replace, take your machine
to an Authorized Service Dealer.
Tensioning the Alternator Belt
1. Place a handle between the alternator and cylinder
block.
2. Adjust the alternator to the outside until there is 7 to 9
mm (1/4 to 11/32 inch) deflection in the belt between
the engine and the alternator pulleys with 10 kgf (22.1
lb of force) (
Figure 72 ).
3. Tighten the alternator bolts.
4. Check the deflection in the belt again and adjust the
belt if needed.
5. If the deflection is correct, tighten the bottom and
upper bolt (
Figure 72 ).
Figure 72
1. Alternator 4. Top bolt
2. Alternator belt 5. Bottom bolt
3. Deflection, 7 to 9 mm (1/4
to 11/32 inch) with 10 kgf
(22.1 lb of force)
Controls System
Maintenance
Adjusting the Control Handle
Neutral Position
If the motion-control levers do not align, or move easily into
the console notch, adjustment is required. Adjust each lever,
spring, and rod separately.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the seat and tilt the seat forward.
4. Begin with either the left or right motion-control lever.
5. Move the lever to the N
EUTRAL
position but not
locked ( Figure 73 ).
6. Pull the lever back until the clevis pin (on arm below
pivot shaft) contacts the end of the slot (just beginning
to put pressure on the spring) (
Figure 73 ).
7. Check where the control lever is relative to notch in
console (
Figure 73 ). It should be centered allowing
lever to pivot outward to the N
EUTRAL
-
LOCK
position.
Figure 73
1. N
EUTRAL
-
LOCK
position 3. Neutral potion
2. Control lever
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (
Figure 74 ).
9. Apply slight rearward pressure on the motion-control
lever, turn the head of the adjustment bolt in the
appropriate direction until the control lever is centered
in the N
EUTRAL
-
LOCK
position ( Figure 74 ).
Note:
Keep rearward pressure on the lever to keep
the pin at the end of the slot and allow the adjustment
bolt to move the lever to the appropriate position.
53