Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 36 / 72

Greasing the Mower Deck and
Belt Idlers
Service Interval: Every 25 hours—Grease the mower deck
and spindles.
Every 25 hours—Grease the mower belt idler arm.
Every 25 hours—Grease the pump belt idler arm.
Every 25 hours—Grease the PTO drive belt idler arm.
Grease with No. 2 lithium or molybdenum grease.
Important:
Make sure that the cutting-unit spindles are
full of grease weekly.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bottom bolt holding the mower-deck
curtain to the mower deck. Refer to
(page ) .
4. Remove the sheet-metal guard. Refer to (page )
5. Remove the belt covers.
6. Grease the 3 spindle bearings until grease comes out
the lower seals (
Figure 40 ).
7. Grease the idler arm on the mower deck ( Figure 40 ).
8. Grease the fittings on the push arms ( Figure 40 ).
Figure 40
9. Grease the PTO drive belt idler arm ( Figure 41 ).
10. Grease the pump belt idler arm ( Figure 41 ).
Figure 41
11. Install the belt covers.
12. Install the sheet-metal guard. Refer to (page ) .
13. Tighten the bolt for the mower-deck curtain. Refer
to
(page ) .
Lubricating the Caster-Wheel
Hubs
Service Interval: Yearly
1. Shut off the engine, wait for all moving parts to stop,
and remove the key. Engage the parking brake.
2. Remove the caster wheel from the caster forks.
3. Remove the seal guards from the wheel hub ( Figure 42 ).
Figure 42
1. Seal guard 2. Spacer nut with wrench
flats
4. Remove 1 of the spacer nuts from the axle assembly in
the caster wheel. Note that thread locking adhesive
has been applied to lock the spacer nuts to the axle.
Remove the axle (with the other spacer nut still
assembled to it) from the wheel assembly.
36