Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 25 / 72

Stopping the Machine
To stop the machine, move the traction control levers to
the N
EUTRAL
position and then to the L
OCKED
position,
disengage the power takeoff (PTO), and turn the ignition
key to the O
FF
position.
Set the parking brake when you leave the machine; refer to
Adjusting the Parking Brake (page 50) . Remove the key from
the ignition switch.
CAUTION
Children or bystanders may be injured if they
attempt to move or operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Adjusting the Height of Cut
Adjust the height of cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the pin
into different hole locations.
1. Raise the height-of-cut lever to the T
RANSPORT
position (also the 127 mm (5 inch) cutting-height
position) (
Figure 19 ).
2. To adjust, remove the pin from the height-of-cut
bracket (
Figure 19 ).
3. Select a hole in the height-of-cut bracket corresponding
to the height of cut desired and, insert the pin (
Figure
19 ).
4. Move the lever to the selected height.
Figure 19
1. Height-of-cut lever
2. Pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is recommended to
adjust the height of the anti-scalp rollers.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height of cut, adjust the rollers by
removing the flange nut, bushing, spacer, and bolt
(
Figure 20 , Figure 21 , and Figure 22 ).
Note:
The 2 middle rollers do not have a spacer
( Figure 21 ).
4. Select a hole so that the anti-scalp roller is positioned
to the nearest corresponding height of cut desired.
5. Install the flange nut bushing, spacer, and bolt. Torque
the bolt to 54 to 61 N∙m (40 to 45 ft-lb) (
Figure 20 ,
Figure 21 , and Figure 22 ).
6. Repeat this adjustment on the other anti-scalp rollers.
Figure 20
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
25