WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
•
Use extreme caution when operating a machine
on a ramp.
•
Ensure that the ROPS is in the up position and
use the seat belt when loading or unloading the
machine. Ensure that the ROPS clears the top
of an enclosed trailer.
•
Use only a full-width ramp; do not use individual
ramps for each side of the machine.
•
Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
•
Ensure that the length of ramp is at least 4 times
as long as the height of the trailer or truck bed to
the ground. This ensures that ramp angle does
not exceed 15 degrees on flat ground.
•
Back up ramps and drive forward down ramps.
•
Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
g027996
5
1
2
6
Figure 33
1.
Full-width ramp in stowed
position
4.
Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2.
Side view of full-width
ramp in loading position
5.
H= height of the trailer or
truck bed to the ground
3.
Not greater than
15 degrees
6.
Trailer
30
Summary of Contents for Z Master Professional 7000Series 74264TE
Page 67: ...Schematics g012068 Wire Diagram Rev A 67...
Page 68: ...Notes 68...
Page 69: ...Notes 69...
Page 70: ...Notes 70...
