Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 51 / 72

8. Install the new belt around the mower pulleys and the
gearbox pulley under the engine (
Figure 68 ).
Figure 68
1. Mower belt 4. Belt guide
2. Mower spindle pulley 5. Gearbox pulley
3. Mower idler pulley 6. Spring
9. Install the belt guide on the spring loaded idler at a 45
degree angle as shown in
Figure 68 .
10. Torque the bolt to 37 to 45 N∙m (27 to 33 ft-lb).
11. Install the idler spring to the 2 posts ( Figure 68 ).
12. Install the belt covers by sliding the cover into the tab,
tighten the bolts, and close the latches (
Figure 67 ).
13. Install the sheet metal guard. Refer to (page ) .
14. Tighten the bolt for the mower-deck curtain. Refer
to
(page ) .
Replacing the PTO Drive Belt
Service Interval: Every 50 hours—Check the PTO drive
belt.
Important:
The fasteners for the front engine panel are
designed to remain on the machine after cover removal.
Loosen all of the fasteners a few turns so that the panel
is loose but still attached, then go back and loosen them
until the panel comes free. This prevents you from
accidentally stripping the bolts free of the retainers.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Tilt the seat forward, loosen the bolts and remove the
front engine panel (
Figure 69 ).
G012347
1
1
2
Figure 69
1. Bolts 2. Front engine panel
4. Remove the spring from the idler arm ( Figure 70 ).
5. Remove the clutch-stop bracket.
6. Remove the old PTO drive belt.
7. Install the PTO drive belt around the clutch pulley and
the gearbox pulley (
Figure 70 ).
8. Install the rubber clutch stop.
9. Install the spring to the idler arm ( Figure 70 ).
10. Install the front engine panel.
51