Lubrication
Lubricate the machine when shown on the Check Service
Reference Aid decal (
). Grease more frequently
when operating conditions are extremely dusty or sandy.
Grease Type: No. 2 lithium or molybdenum-base grease
1.
Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3.
Clean the grease fittings with a rag. Make sure that you
scrape any paint off the front of the fitting(s).
4.
Connect a grease gun to the fitting. Pump grease into
the fittings until grease begins to ooze out the bearings.
5.
Wipe up any excess grease.
Greasing the Front Caster
Pivots
Service Interval:
Yearly
Lubricate the front caster pivots once a year.
1.
Remove the dust cap and adjust the caster pivots.
Keep the dust cap off until greasing is done. Refer to
Adjusting the Caster-Pivot Bearing (page 46)
.
Remove the hex plug. Thread a grease fitting into the
hole.
2.
Pump grease into the fitting until it oozes out around
the top bearing.
3.
Remove the grease fitting in the hole. Install the hex
plug and cap.
Adding Grease
Lubricate the grease fittings as shown on the Check Service
Reference Aid decal (
).
Figure 39
Adding Light Oil or Spray
Lubrication
Service Interval:
Every 150 hours
Lubricate the machine in the following areas with spray type
lubricant or light oil.
•
Seat switch actuator.
•
Brake handle pivot.
•
Brake rod bushings.
•
Motion control bronze bushings.
35
Summary of Contents for Z Master Professional 7000Series 74264TE
Page 67: ...Schematics g012068 Wire Diagram Rev A 67...
Page 68: ...Notes 68...
Page 69: ...Notes 69...
Page 70: ...Notes 70...
