Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 41 / 72

Fuel System
Maintenance
Servicing the Fuel Filter
Draining the Water Separator
Service Interval: Every 40 hours
1. Position the machine on a level surface.
2. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Locate the water separator at the back left of the
machine.
5. Place a drain pan below the water separator.
6. Open the drain valve on the water separator
approximately 1 turn to allow water and other
contaminates to drain (
Figure 51 ).
7. Close the drain valve when only diesel fuel comes out
(
Figure 51 ).
Figure 51
1. Drain valve 3. Back of the machine
2. Water separator
Changing the Fuel Filter
Never install a dirty fuel filter if it is removed from the fuel
line.
1. Allow the machine to cool down.
2. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Close the fuel shut-off valve( Figure 52 ).
5. Loosen the 2 hose clamps and disconnect the fuel lines
from the fuel filter (
Figure 52 ).
6. Install a new filter. Connect the fuel lines to the fuel
filter and install the hose clamps (
Figure 52 ).
7. Open the fuel-shutoff valve.
8. Start the engine and check for leaks.
Figure 52
1. Fuel filter 4. Left side of the machine
2. Hose clamp 5. Fuel-shutoff valve
3. Fuel pump
41