Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 26 / 72

Figure 21
1. Anti-scalp roller 3. Flange nut
2. Bushing 4. Bolt
Figure 22
1. Flange nut 4. Anti-scalp roller
2. Spacer
5. Bolt
3. Bushing
Adjusting the Flow Baffle
You can adjust the mower discharge flow for different types
of mowing conditions. Position the cam locks and baffle to
give the best quality of cut.
1. Disengage the PTO, move the motion-control levers to
the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the cam locks, swing the lever up to loosen
the cam lock (
Figure 23 ).
4. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5. Swing the lever back over to tighten the baffle and cam
locks (
Figure 23 ).
6. If the cam locks do not lock the baffle into place or it
is too tight, loosen the lever and then rotate the cam
lock. Adjust the cam lock until you achieve the desired
locking pressure.
Figure 23
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments vary by grass type, moisture content, and height
of grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. Use this position for the
following:
•
Short, light grass mowing conditions.
•
Dry conditions.
•
Smaller grass clippings.
•
Propelling grass clippings farther away from the mower.
Figure 24
26