Toro Z Master Professional 7000Series 74264TE, Operator'S Manual

Page: 44 / 72

Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important:
Always keep the battery fully charged (1.265
specific gravity). This is especially important to prevent
battery damage when the temperature is below 0°C
(32°F).
1. Make sure that the filler caps are installed in the battery.
Charge the battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (
Figure 55 ).
3. Install the battery in the machine and connect the
battery cables, refer to
Installing the Battery (page 43) .
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 55
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
1. Unlatch the engine hood and raise the engine hood to
gain access to fuse holder (
Figure 56 ).
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse ( Figure 56 ).
1
3
2
G012492
4
Figure 56
1. Ignition—30 A (F1) 3. Clutch—10 A (F3)
2. Radiator fan—50 A (large,
heavy duty fuse) 4. Left side fuel tank
44