Toro Z Master Professional 7000 Series, Operator'S Manual

Page: 37 / 364

Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Rotate the bypass valves counterclockwise 1
turn to push (
Figure 39 ).
Note:
This allows hydraulic fluid to bypass the
pump enabling the wheels to turn.
Important:
Do not rotate bypass valves
more than 1 turn. This prevents valves from
coming out of the body and causing fluid to
run out.
4. Disengage the parking brake before pushing.
Changing to Machine Operation
Rotate the bypass valves clockwise 1 turn to operate
machine (
Figure 39 ).
Note:
Do not over-tighten the bypass valves.
Important:
The machine does not drive unless
bypass valves are turned in.
g010371
Figure 39
1. Side console controls 3. Hydraulic pumps
2. Bypass valve
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
35