Toolots HS-DP Series, Manual

Page: 32 / 33

32
5. the driving cable lack of
connection or line break Check the line
the 19 pin or 16 pin
6. plug is not connect well. Or
line break
Check the line
7. gear wheel or the belt loosen Check or adjust it.
The printing needle
moving track is
abnormal
1. the file input failure Read the instruction
and re input
2. the control software damaged Re install it
3. the computer effect by virus. Clean it
The printing needle not
stricking 1. there is no air pressure Check the air source
2. the
electric
valve
not
working Contrl board
brocken
Change it
Electro-valve
brocken(DC24V) Change it
Line is on good Check the line
The printing needle
striks none stopping or
the strike force is small
1. lack of air flux Change the big air
tube
2. the air switch not opened
enough, Open it bigger
3. the spring is seizured inside
the sheath of the printing
needle Check and clean it
4. the aire pressure is too
low()0.3-0.6Mpa Adjust the pressure
5. the lubrication on the needle is
no good Add some lubricant
The needle striking
frequency decreased
1. the spring inside is worn out
2. some forign stuff within the
needle
Change it
Clean it
Printing character has a
smearing phenominom 1. some forign staff goes into the
electro-valve Clean it
2. the air close parameter setting
is too small Re set it (larger)
3. the control program is
damaged
Re install it
abnormal reset 1. control board damaged Change it