30
the printing needle will strick up and dwon repeatedly, since there has friction
between the needle and the sheath, so after long time of working, both of the needle
and the sheath may be worn out, and the gap between the needle and the sheath will
enlarged, this will directly effected the marking results. When doing the service, take
out the needle from the sheath, clean it with gasoline and then apply with some of
lubricant, reinstall it into the sheath. This work has to be carried on repeatedly every
one or two weeks.
2. machine head maintnance: the machine head is mainly composed by linear guiding
rail and the motor. Since the the guiding rail will directly contact with the working
parts, and there are some metal dust produced during its marking thus it will easily
damaged the guiding rail, as the time being, the rail will be worn out, so clean this
area with gasoline and apply with lubricant periodically is needed.it is suggest twice a
week. During the cleaning, it have to avoid the oil get in touch with the timing belt.
3. Maintenance for the controller: Since it is the machine‟s own feature that it will
exposed in the air for long while, so after long while, the circuit board may gethered
with dusts, if not clean it periodically, a circuit break may occurred. The way of
cleaning the dust is: switch off the power of the controller, open the external machine
box, clean them with pressured gas to blow on it. Pay attention to clean the dust
around the machine all the time.
Maintenanc of the computer. As long while of using, the system also will produce a
large quantity of rubish, if not clean them on time, it will affect the working of the
software. The cleaning works including:
1.
delete the rubish files and the un-neccessory software
documents.
2.
periodically tidy up the hard disk for sure the datas are in
reasonable order, which can accelerate the operation of the
software.
3.
do not add the unknown files and softwares into the system, for
avoid the computer virus attachs. Guarentee the system is
working under a good environment.
This work requires the operator has a certain amount of
computer knowlage, other wise, contact our company for
technical back up supporting.
Trouble shooting for the system and the frequently appeared failures.
On the form below, it listed some of minor failures frequently emerged during
working, the operator can solve these problems by themselves under the preconditions
of familiar with the product. Thus to keep the equipment working normally.
Phenominom of the
failures
Reason
solution
The main machine of
the computer is not
working,
but
the
indicator of the monitor
is shine.
1
．
The
power
source
is
damaged.
Invite
the
professionals to come
or change it.
2
．
Problem
on
other
hardware
Invite
the
professionals to come
Summary of Contents for HS-DP Series
Page 2: ...2 Air Power switch button Start Marking button Machine top view...
Page 4: ...4...
Page 7: ...7...
Page 8: ...8 Marking results...
