26
before the start of marking, we should first understand the concept of the marking
sequence. When there is only one mark emerged in the interface, the marking
sequence does not means of anything, but when there are more marks emerged there,
most of the chances we will need to set a marking order to speed up the marking
process. By default, the marking is based on the establishment of the order to carry
out, that is, the mark first established in marking will go first, the mark established
later will start later on, some times,
in some cases, this is no problem, but if we think this order is not reasonable,and
needs an adjustment, then click the menu [marking] and [marking order] to open the
marking
order
adjustment
window,
as
per
shown
here:
in this Marking order adjusting window, the list is in order according to the
present marking contents as whell as its location, choose one of them and then click
"Move Up" or "Move Down" could change its marking order. A simplest approach is
to click on "Automatic sorting" button, marking control software will automatically
start from the top to bottom, left to right to reordering it, which is the most commonly
used sorting method.
2.6.2 Set Marking
"Marking speed" refers to the engraving needle marking speed, "empty working
speed" indicates of the needle in the non-marking status movement (ie the empty
moving), properly set and match these two speeds can make the marking more
effeciantly and while will not effect its precesioin. Normally the empty moving speed
can be fasterr than the marking speed, but preferably not more than 20 or more.
speed setting is very simple, you can directly drag the speed control bar, and can also
directly input text in the parameter box on the right.
Beside, in case you have not open the setting window of the marking machine, it can
directely use the key of "+","-" to set up marking speed, every time press the "+","-"
buttom, the marking speed will increase or decrease, if to press and hold the [Shift]
key, every time press the "+","-", it will increase or decrease in marking speed of 10.
Because the needle marking process is initiated by high-pressure gas control, proper
operation with the high-pressure gas can avoid "missing marking" and "tail" marking
effects, the following figure:
Summary of Contents for HS-DP Series
Page 2: ...2 Air Power switch button Start Marking button Machine top view...
Page 4: ...4...
Page 7: ...7...
Page 8: ...8 Marking results...
