Toolots HS-DP Series, Manual

Page: 31 / 33

31
or do the maintenance
The main machine is
working
but the
monitor is not display
1. displaying card damaged, or
the connection with the main
board is not good.
Change it or reinsert it
2. monitor is brocken Invite the
professionals to come
3. the signal cable is not
properly inserted
4.
Reinsert it.
Communication fails 1. USB drive fails Reinstall it
2. bad connection on USB drive
or line break Reinsert, change it or
check accordingly
Printing needle refuse
to move, the printing
indicator not light on 1. the driving cable connection
is not
good, or line break,
Check the line or
re-insert it
2. the 19 pin or 16 pin
plug is not connect well.
Check the line
3. the control software
is damaged.
Re install it
4. failure on some part of the
control board. Change it or repire.
The printing needle
refused to move,, but
the indicator is on
1. driving cable contact problem
or line cut Check the line
the 19 pin or 16 pin
2. plug is not connect well.
Check the line
3. dive circuit damaged Check the circuit
Needle in X or Y
direction
refuse to
move
1. the control board brocken or
bad connection. Change it or reinsert it
2. bad signal on the line of X or
Y direction Check it
3. diving board brocken on X or
Y direction Change it
4. motor brocken on X or Y
direction Change it