Toolots HS-DP Series, Manual

Page: 20 / 33

20
Note: once the type of a mark is being selected, it will not be changed anymore.
Since the establishing way of both the [text] and [fan shaped text] are basically the
same, so here we will introduce their using method all together.
After the text type of mark being selected in the list of marking type, the related
parameters will display in the “marking” panel, this has been introduced before in the
2.1 Quick Start section, here we will brief the functions of the parameters one by one.
Content: As the name suggests, here you can change the marking text.
X, Y, Z: these three parameters used to specify the tag positions in the engraving area.
This position can be varied according to the type of the tag text. Standard [text]
marking position is to indicate the position of the lower left corner of the engraving
tag, whilst the [fan the text] standard position is means of the center arrangement of
the radius of the characters. Here be ware of the “Z”, this “Z” position can only be
enabled when after the Z-axis lifting movements feature are activated. When your
marking machine has possessed a lifting function, the Z position now can be set of the
surface height of the tag engraving.
c. Angle: this is a designated angle that rotates around the X and Y axis, to the
[fan-shaped text], this angle means the start and ending angle of the arrangement of
the fan shaped characters.
d. English Font: Font name of the used English words, numerical numbers, symbols.
e.
Chinese font: fonts of Chinese characters that used in tag contents. Note, after you
input a Chinese content, this character must have to select a Chinese character font,
otherwise, the newly created marks will not be normally displayed or to lead an
invalid marking.
f. height and width of the characters: This is the dimension of the marking contents.
Here to be attention, the height and width of the character can not absolutely
determine the size of the characters, which can only be a reference of dimension. The
actual character size will determine finally by deferent fonts in characters. For
example, when a character width is setting as 5mm, the width of numerical number
“1” are normally can not reach 5mm, also along with the change of shape of the
characters the width will also differs, for example, font
"ISOCP.TEF “‟s numerical character “1” is slightly wider than the font of
"STENCIL.TEF". see the following figure:
g. Word spacing: tag the content distance between characters and character.
h. Radius (fan version): fan outside the radius of inscribed circle.