Thermo Scientific Thermo Scientific Vanquish VC-D40, Operating Manual

Page: 132 / 174

7 • Maintenance and Service
Page 132 Variable Wavelength Detectors (VC-D40, VF-D40)
Operating Manual
Figure 29: Pulling out the slide-in module
NOTICE
The slide-in module can fall down when pulling it out of the enclosure
too far.
Pull out the slide-in module just far enough so that you can grasp it on
both sides from below.
4. Remove the slide-in module from the enclosure. The following steps
require a team effort:
a) Take the slide-in module on both sides from below.
b) Pull the slide-in module from the rails towards the front.
c) Place the slide-in module on a clean and stable surface.
7.13.2 Returning the Slide-In Module
Preparation
If not yet done: Remove the slide-in module from the enclosure. See
Removing the Slide-In Module (
}
page 131) .
Follow these steps
1. Install the slide-in module to the enclosure of the replacement
device. Follow the steps for inserting the slide-in module in the
enclosure and tightening the captive screws in
Installing the Slide-In
Module ( } page 133) .
2. Follow the instructions in Shipping the Device (
}
page 130) .