Thermo Scientific Thermo Scientific Vanquish VC-D40, Operating Manual

Page: 71 / 174

5 • Installation
Variable Wavelength Detectors (VC-D40, VF-D40)
Operating Manual Page 71
5.8.5.2 Connecting the Detector Waste Line
Preparations
1. See Flow Connections to the Flow Cell (
}
page 68) .
Follow these steps
1
2
3
Figure 20: Connecting the detector waste line
1. Connect the waste line to the flow cell outlet or to the outlet ( OUT )
on the flow cell connection unit (1).
2. Route the waste line through the top recess (2) in the partition
panel.
3. Route the waste line through the tubing guides of the system
modules below the detector to the Vanquish system base (3).
4. On the system base, route the detector waste line through the
dedicated detector waste outlet to waste and connect the detector
waste line to the waste container as described in the
Vanquish
System Operating Manual .
TIP
The waste line should go straight to the system base and to waste. Make
sure that the line is positioned straight in the tubing guides.
5. If you have to cut tubing to length, use a tubing cutter. Make sure
that the cut is at right angle to the length of the line and that the cut
is not crimped.