Dionex AutoTrace 280 Operator’s Manual
58
Doc. 065330-05 03/2020
3.7.2
Making the Required Changes
1. Load the method into the Set Up Methods window (see
2. On the toolbar, click
Edit
.
3. If you want to save the edited method to a new method:
a.
Enter a new method name in the
Name
box.
b. Click the down arrow next to
Save
, and select
Save as new
Method
.
c.
Click
Edit
to return to editing mode.
4. To edit the settings of an existing step:
a.
In the method step table in the lower-right section of the window,
select the step to be edited. The current settings for the step are
displayed above the table.
b. Change the settings as required.
5. To delete a step, double-click its entry in the method step table.
6. To add a step:
a.
In the method step table, click the step
above
where you want to
add the new step.
b. In the command list in the left pane of the window, double-click
the command. The command is added to the table below the
selected step. For details, refer to the “Method Command
Descriptions” topic in the AutoTrace software Help.
NOTE A method can have a maximum of 45 steps.
7. To edit the Dionex AutoTrace 280 operating parameters that will be
in effect when the method is run, click
Params
on the toolbar. For
details, refer to the “Set Up Method Operating Parameters” topic in
the AutoTrace software Help.
8. To undo changes and restore the previous entries, click
Undo
on the
toolbar.
9. When changes are complete, click
Save
on the toolbar.
