![background image](http://html1.mh-extra.com/html/thermo-king/slxi-100/slxi-100_maintenance-manual_1104353055.webp)
TK 61555-2-MM-EN
55
Figure 24.
Place Injection Angle Sticker on Gear Case
1.
Index Mark on Injection Pump
2.
Injection Angle Sticker
Figure 25.
Injection Angle Sticker
1.
–1.0 Degrees Mark
2.
Center Line (0 Degrees Mark)
3.
+1.0 Degrees Mark
3. Remove the old injection pump. Use the injection pump gear tool P/N 204-1011 to remove the
injection pump gear without removing the timing gear cover (see
).
N
No
otte
e:: Remove the injection pump gear by removing the nut and lock washer that secure the
injection pump gear assembly to the injection pump shaft. The injection pump gear
assembly is made of three pieces; the flange, the gear, and the transfer pump cam. Do
not loosen or remove the four bolts that fasten the gear to the flange because that
changes the factory-set timing. The EPA certification is based on the factory-set timing.
If the factory-set timing is changed, the EPA certification is void.