![background image](http://html1.mh-extra.com/html/thermo-king/slxi-100/slxi-100_maintenance-manual_1104353129.webp)
TK 61555-2-MM-EN
129
Figure 108.
Fan Shaft Housing
1.
Apply Bead of Loctite 603 to Leading Edge of Machined
Bore
Figure 109.
Fan Shaft and Housing
1.
Apply Bead of Loctite 603 to Leading Edge
2.
Apply Bead of Loctite 603 to Outer Races
10. Insert the fan shaft and bearings into the evaporator end of the housing. Make sure the
bonding surfaces of the housing and bearings are well covered with Loctite 603.
N
No
otte
e:: Loctite 603 and Loctite 7240 (activator) will begin to bond within seconds upon contact.
N
No
otte
e:: Curing time for Loctite 603 is 6 hours when Loctite 7240 (activator) has been used. Do
not install the fan shaft in the unit until the Loctite has cured.
11. Install the wave washer on the condenser end of the fan shaft.
12. Install the bearing on the condenser end of the fan shaft.
13. Install the snap ring on the condenser end of the fan shaft.
Installation
1. Make sure the key is in place in the evaporator end of the fan shaft.
2. Install the fan shaft while sliding the evaporator blower onto the end of the fan shaft.
3. Install and tighten the fan shaft mounting bolts.