![background image](http://html1.mh-extra.com/html/thermo-king/slxi-100/slxi-100_maintenance-manual_1104353132.webp)
132
TK 61555-2-MM-EN
Figure 111.
Cross Shaft Assembly
1.
Snap Ring
5.
Cross Shaft
2.
Bearing
6.
Key
3.
Wave Washer
7.
Engine Pulley End
4.
Housing
8.
Fan Pulley End
Reassembly
IIm
mp
po
orrtta
an
ntt:: To prevent damage to the bearings, use bearing drivers (or other suitable tools) on
the bearing races when installing the bearings.
N
No
otte
e:: Place a thin layer of grease (Mobil 28 or its equivalent) on the inner and outer bearing races
before assembly.
1. Install a bearing on the fan pulley end of the cross shaft. The fan pulley end does not have a
threaded hole.
2. Install the snap ring on the fan pulley end of the cross shaft.
3. Insert the cross shaft and bearing into the fan pulley end of the housing.
4. Install the wave washer on the engine pulley end of the cross shaft.
5. Install the other bearing on the engine pulley end of the cross shaft.
6. Install the snap ring on the engine pulley end of the cross shaft.
Installation
1. Place the cross shaft in position. Make sure with the engine pulley end is located on the
engine/cross shaft belt side.
2. Install and tighten the cross shaft mounting bolts.
3. Make sure the key is in place in the engine pulley end of the cross shaft.
4. Place the cross shaft/engine pulley on the cross shaft. Position it axially using block P/N
2042435 between the pulley and the cross shaft mounting bracket and tighten the pinch bolts.
5. Make sure the key is in place in the fan pulley end of the cross shaft.
6. Place the cross shaft/fan pulley on the cross shaft, slide it into position to where it is aligned
correctly with the other pulleys and tighten the pinch bolts.
7. Install the engine/cross shaft belt. See “Engine/Cross Shaft Belt” in the Engine Maintenance
Chapter.
8. Install the fan drive belt. See “Fan Drive Belt” in the Engine Maintenance Chapter.