18
TK 61555-2-MM-EN
Maintenance Inspection Schedule
N
No
otte
e:: Please refer to your SLXi Operator Manual TK 61452-2-OP for Operator Weekly Checks
The service technician is responsible for assessing the condition
of all parts & components found during any service operation to
be in a condition suitable for further operation up to the next
scheduled service. If parts not considered in suitable condition
they should be replaced.
Inspect/Service These Items
INSPECTION
A SERVICE
Every 1500
hours Or
every 12
Months
(whichever
comes first)
B SERVICE
Every 3000
hours Or
every 24
Months
(whichever
comes first)
SERVICE C
SERVICE
Every 6000
hours Or
every 48
Months
(whichever
comes first)
EDAC Labour Standard
Single Temperature Units
1.0 hr
2.5 hrs
7.0 hrs
Microprocessor:
Run Pretrip Test (see “Performing a Pretrip Test”).
Engine and Unit Maintenance Items:
Download ServiceWatch data-logger - Check alarm codes, system operation,
function and take corrective action as required.
•
•
•
Check for faults and operation of the Blue Box.
•
•
•
Check HMI & Controller software revision - Upgrades not included
•
•
Check fuel supply.
•
•
•
Check and adjust engine oil level.
•
•
•
Change engine oil (hot) and oil filter.
•
•
*Check and adjust engine coolant level and protection, maintain protection at
35 C (95 F) (or lower if operating in very low ambients).
•
•
•
Inspect compressor, fan drive & water pump belts for condition and tension.
Adjust if necessary.
•
•
Replace all belts.
•
Inspect belt tension devices and belt idler pulley for condition and proper
tension.
•
•
•
Inspect the Fan belt tensioner assembly (77-3192). Not possible to
disassemble, clean or grease new style fan belt tensioner.
•
•
•
Inspect condition of drive coupling bushings and pins when compressor belt is
replaced (Model 30 units)
•
Inspect clutch drive bushings and pins, clutch bearings & shoe wear when
compressor drive belt is replaced.(Model 50 units)
•
Check water pump seal for weep age and bearing serviceability.
•
•
•
Listen for unusual noises, vibrations, etc.
•
•
•
Visually inspect exhaust system for leakage and abnormal smoke or particulate
emissions.
•
•
Check and adjust engine speeds (high and low speed).
•
•
•
Inspect cyclonic air filter element - Dependent on operating conditions, assess
fitness to continue to next service.
•
