Texas Instruments TMS320C3 Series, User Manual, Page: 23 / 166

Step 2: Installing the DSK Software / Step 3: Modifying Your config.sys File
2-5 Installing the DSK Assembler and Debugger
2.3 Step 2: Installing the DSK Software
This section explains how to install the debugger software on a hard disk sys-
tem.
1) Make a backup copy of the product disk. (If necessary, refer to the DOS
manual that came with your computer).
2) On your hard disk or system disk, create a directory named dsktools. This
directory will contain the DSK assembler and debugger software. To
create this directory, enter:
md c:\dsktools
3) Insert your product disk into drive A. Copy the contents of the disk using
the following command:
copy a:\*.*c:\dsktools\*.*/v
2.4 Step 3: Modifying Your config.sys File
When using the debugger and assembler, you can open multiple files. To allow
enough environment room, it is recommended that the following line be added
to the config.sys file:
FILES=20
Once you edit your config.sys file and add the line, invoke the file by rebooting
the PC (press the reset switch, or turn off the PC’s power and turn it on again).