6 Using the product
121
Once the measurement has ended, the radio probe
should continue to run for a further two communication
cycles for data synchronisation before another
measurement can be started again.
To start a new project, you must register all components
on the Saveris base again and then restart the
hardware.
Pos: 156 /TD/Produkt verwenden/testo Saveris/09 Einstellungen System/00 Einstellungen System @ 0\mod_1189493729343_79.docx @ 4233 @ 3 @ 1
6.9.
System settings
In this menu, determine the settings for the Saveris base, the radio
probes and – if installed in the measuring system – the Ethernet
probes, router, converter and analog coupler.
> Click
on
System
in the navigation area.
- The following entries are shown in the tree structure in the data
range:
•
Base
with the general settings of the Saveris base and the
SMS module (if present) as well as the operating data of the
probes.
•
Radio probe
with the settings for the radio probes or radio
analog couplers connected to the Saveris base.
•
Ethernet probe
with the settings for the Ethernet probes or
Ethernet analog couplers attached to the Saveris base.
•
Router
with the settings for the routers connected to the
Saveris base.
•
Converter
with the settings for the converters connected to
the Saveris base.
Pos: 157 /TD/Produkt verwenden/testo Saveris/09 Einstellungen System/01 Allgemein @ 0\mod_1188997905046_79.docx @ 3801 @ 3 @ 1
6.9.1.
General settings for the Saveris base
Via this menu item, you can for example synchronize the date and
time of the Saveris base with the values of the computer.
1.
Open the
Base
entry.
- The submenu items
General
and
Operating data
are shown
below the entry.
2.
Click on
General
to open the basic settings for the Saveris
base.
- The settings of the Saveris base are shown in the display
range.
