Tescom MTP200B, Operating Manual

Page: 60 / 172

44
WLAN Signal Transmit
MTP200B does not support selective file formatting. Using the Waveform Creator, however, t
he user can selectively format the files.
8.2.6 NUM_PACKET Setting
Enter the total number of WLAN packets to be transmitted by MTP200B between 0 and 10.000. In ca
se of “0,” MTP200B continuously transmits the packets.
(In case of a number between 1 and 10,000, only as many packets as specified will be transmitted.)
●
Select GEN (M1) → SG → NUM_PACKET → Set value between 0 ~ 10 (Default Value: 0)
8.2.7 INTERVAL Setting
Set the WLAN packet transmission interval between 1 and 3,000 ㎲
●
Select GEN (M1) → SG → INTERVAL → Set value between 1 ~ 3,000 ㎲ (Default Value: 10 ㎲)
8.3 WLAN Signal Transmit
1. Set DUT to WLAN signal receiving mode. (Set WLAN signal to be received such as Channel, Data R
ate, etc.)
2. Set MTP200B as follows.
A. Set MTP200B WLAN signal transmit mode and Channel (Refer to the 8.2.1 Mode Setting and
8.2.2 Channel Setting )
B. Set output power to be transmitted (Refer to the 8.2.3 Power Level Setting )
C. Select WLAN waveform file to be transmitted (Refer to the 8.2.5 WLAN Waveform file Setting
)
D. Set WLAN waveform file’s total number of packet and Interval to be transmitted (Refer to the
8.2.6 NUM_PACKET Setting and 8.2.7 INTERVAL Setting )
3. MTP200B transmits WLAN waveform file. ( GEN (M1) → SG → Select RUN → Select ON )
A. Select OFF if a user wants to stop transmitting WLAN waveform file
4. DUT confirms WLAN waveform’s number of packet received. Then, calculate PER comparing it to n
umber of packet transmitted from MTP200B.