Tescom MTP200B, Operating Manual

Page: 81 / 172

BT LE Signal Transmit
65
11.3 BT LE Signal Transmit
1. Set DUT to BT LE packet receiving mode (Test mode, channel, etc.)
2. Set MTP200B as follows.
A. Set MTP200B to BT_LE signal transmit mode and select channel (Refer to the 11.2.1 Mode Se
tting and 11.2.2 Channel Setting )
B. Set output power to be transmitted (Refer to the 11.2.3 Power Level Setting )
C. Set BIT_PATTERN and DATA_LENGTH of BT_LE waveform to be transmitted (Refer to the 11.
2.5 Bit Pattern Setting and 11.2.6 Data Length Setting )
D. Set number of packets to be transmitted (Refer to the 11.2.7 Number of packet Setting )
Figure 11-3 BT_LE GEN Setting Screen
3. BT_LE packet transmit ( GEN (M1) → SG → Select RUN → Select ON )
A. Select RUN → OFF in order to stop BT_LE packet transmit
4. DUT confirms received number of packet of BT_LE. Then, calculate PER comparing it to number of
packet transmitted from MTP200B.
For more details in receive test among 22. BLE RF Test Cases , refer to the 22.2 BLE Receiver T
est Items .