Tescom MTP200B, Operating Manual

Page: 119 / 172

BT_LE Signal Analyzer Command List
103
17.2 BT_LE Signal Analyzer Command List
●
The commands of BT LE signal analyzer can be used for the purpose as follows.
○
Measure and analyze general BT LE signal
●
BT LE RF PHY("RF-PHY.TX.4.2.0") test items (3 items)
○
Output Power
○
Modulation Characteristics
○
Carrier Frequency Offset and Drift
●
Test items for complete product through Advertising Mode (2 items)
○
Output Power
○
Modulation and Frequency Offset
17.2.1 Configuration Command
1. CONF:ANL:CONFIG:MODE BTLE_TEST
○
Description: Set operating MODE to BT_LE TEST mode. For RF PHY Output Power, Modulation C
haracteristics, Carrier Frequency Offset and Drift test items, it must be set as BTLE_TEST mode.
○
Response: OK|ERR
2. CONF:ANL:CONFIG:MODE BTLE_ADV
○
Description: Set operating MODE to BT_LE ADVERTISING mode. For Output Power, Modulation
and Frequency Offset test through Advertising mode of complete products, it must be set as BTL
E_ADV mode.
○
Response: OK|ERR
For above commands, if it is set as BTLE_TEST, it is measured according to Payload Bit Pattern
demanded by test items of Direct Test Mode. However, if it is set as BTLE_ADV, it is measured
(dF0 and dF2) using Bit pattern of Preamble.
3. READ:ANL:CONFIG:TEST_METHOD?
○
Description: Checks the setting of the BT_LE test method
○
Response: TEST_MODE|ADVERTISING
○
Default value: TEST_MODE