Tescom MTP200B, Operating Manual

Page: 127 / 172

CW Signal Analyzer Command List
111
18.2 CW Signal Analyzer Command List
18.2.1 Configuration Command
1. CONF:ANL:CONFIG:MODE CW
○
Description: Sets the CW operation mode
○
Response: OK|ERR
2. READ:ANL:MODE?
○
Description: Checks the operation mode
○
Response: CW|WLAN_11ag|WLAN_11n|BT_LE
○
Default value: WLAN_11ag
3. CONF:ANL:CONFIG:FREQ <Range>
○
Description: Sets the CW input frequency[MHz]
○
Range: 2400.000 ~ 2500.000 MHz, 4900.000 ~ 5875.000
○
Response: OK|ERR
4. READ:ANL:CONFIG:FREQ?
○
Description: Checks the setting of the CW input frequency[MHz]
○
Response: 2400.000 ~ 2500.000, 4900.000 ~ 5875.000
○
Default value: 2412.000
5. READ:ANL:MEAS:CW_POWER?
○
Description: Checks the power[dBm] of the CW input signal (When CONFIG -> MODE is CW, a re
sponse will be returned. In other modes, ERR will be returned.)
○
Response : +20 ~ -85
18.2.2 Path loss Command
1. CONF:ANL:LOSS:CW_<Range> <Loss Value>
○
Description: Set Path Loss according to frequency range under CW mode
○
<Range>: 2G|5G|ALL
■
2G: Apply Path Loss to 2 GHz range (2400 MHz ~ 2500 MHz)
■
5G: Apply Path Loss to 5 GHz (4900 MHz ~ 5875 MHz)
■
ALL: Apply same Path Loss to all frequency range (2400 MHz ~ 2500 MHz , 4900 MHz ~ 58
75 MHz)
○
<Loss Value>: Loss value: 0.0 ~ 50.0
○
Response : OK|ERR