TEG1210P 10-Port Gigabit Intelligent PoE Switch User Guide
Procedures taken to add VLAN groups in Port VLAN mode are listed below:
1. Select a VLAN group number such as “2” from the VLAN Group drop-down list box.
2. Check the ports to join the corresponding VLAN group in VLAN Member box.
3. Click the “Apply” button to complete this operation.
4. The member ports of VLAN2 are displayed in VLAN Group status table.
To refresh member ports of a VLAN group, follow the above procedures for
re-configuration.
To delete all member ports of a VLAN group: Select a VLAN group number from the
“VLAN Group” drop-down list box, and then click the “Apply” button.
3.5.3 802.1Q VLAN
A Tagged VLAN uses port VID to distinguish different VLANs. When frames pass through
a switch, the VID information in tag header is used to identify the VLANs to which they
belong. And the switch will then decide to which ports such frames should be forwarded
according to current VALN configuration.
To enter the page below, click “VLAN Setting”—“802.1Q VLAN" tabs as shown in the
figure below:
1. Steps taken to create a VLAN group are listed below:
（
1
）
Enter a new VLAN ID such as 4094 in the VLAN ID box; The allowed ID value
ranges from 1 to 4094.
（
2
）
Check the port numbers such as 1,2,3 to join VLAN 4094 in VLAN member box as
- 29 -
