TEG1210P 10-Port Gigabit Intelligent PoE Switch User Guide
Speed Duplex Allows you to manually configure 5 working modes: 10Mbps
half-duplex, 10Mbps full-duplex, 100Mbps full-duplex, 100Mbps
half-duplex and 1000Mbps full-duplex
Note: only after auto-negotiation is disabled, can duplex mode be
configured
Flow Control
IEEE802.3x in full duplex and backpressure flow control in half
duplex are supported (Switch automatically changes flow control
according to a port's duplex mode)
The actual information of each port is displayed in the “Port Status” table below.
3.3.2 Mirror Config
Port mirroring function is implemented by copying packets through one or more monitored
ports to a monitoring port (mirroring destination port) for the purpose of analyzing and
monitoring packets. For example: you can copy packets through monitored port (mirroring
source port) 3 to monitoring port (mirroring destination port) 4 so as to test and record the
working status of port 3 through the protocol analyzer connected to port 4.
Through proper configuration, TEG1210P can support cross-VLAN and
cross-switch-VLAN port mirroring.
To enter port mirroring configuration interface, click “Port Management”
→
“Mirror Config”
as shown below. The configuration procedures are listed below:
(1) Select a mirror port (monitoring port) from the “Mirror Port” drop-down list box (only
one mirror port is allowed).
(2) Check one or more ports for mirrored port(s) in mirrored port box.
(3) Click the “Apply” button to complete the configuration.
- 17 -
