TEG1210P 10-Port Gigabit Intelligent PoE Switch User Guide
To enter the page below, click “Function Setting”—“SNMP Config".
To configure the parameters on the above page, just enter values you want to configure
and then click the “Apply” button to finish.
Fields on the above page are described as below:
Field Description
SNMP Enabled
Check the box to enable SNMP management function
SNMP
Trap Destination
The destination IP address to which switch’s trap information is
going to send
SNMP
Read Community
Configure the read-only community name of the SNMP
information of the switch. To read the SNMP information of the
switch, SNMP management software must contain the same
read-only community name
SNMP
Write Community
Configure the writable community name of the SNMP
information of the switch. To modify the SNMP information of
the switch, SNMP management software must contain the
same write community name
SNMP
Trap Community
Used by the SNMP management software to judge the validity
of trap message by identifying the trap community name
3.5 VLAN Setting
The switch supports 2 types of VLANs: Port VLAN and 802.1Q VLAN; by default it is in
Port VLAN mode.
- 27 -
