TEMA TELECOMUNICAZIONI SRL
IP Module AA-600
MAS-AA600-REV02EN
Page 31 of 56
9.14. Messages management
In this window it is possible to change/listen to the messages for “Calling”, “Alarms”, “Announcement” and “Ringer”.
Memory contains a default message for each position, the user can change any of them and the messages format
must be WAV PCM 8 kHz, 16 bit, mono.
“Call message”, from 1 to 5, can be reproduced when one of the call button is pressed. The activation and
deactivation of the message is done remotely, directly from an extension phone. It is possible to enter up to 5 wav
messages to be chosen later in the combination of key presses.
“Alarm messages”, one for each input, are reproduced to the called telephone number configured in the alarm input
(from 1 to 6): when the called answers, the message is played continuously, until the user enters the stop code or a
timeout expires. “SIP Alert Call Button” function.
I “Ann. Messages”, also one for each input, are reproduced on the local speaker when the relative check in the
alarm mask is selected (see par. 9.10) and the input is active. The message is played before calling. It is possible
to play each message also during a call (see ahead) using a particular code.
These messages can also be
played by reaching the system via telephone (see just below) using the relevant activation code.
At the end, the “Night ringer” (2
nd
Acc.) is played on the local speaker when a call is received on the second SIP
account, if programmed. (par.
Errore. L'origine riferimento non è stata trovata.
).
