LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 176 of 273
#LTEDS – Read current network status in E-UTRAN
1 : "WAIT4ESM_REP"
//EMM_WAITING_FOR_ESM_RESPONSE
Note : RRC
0 : IDLE_STATE
1 : WAITING_FOR_RRC_CONFIRMATION_STATE
2 : CONNECTED_STATE
3 : RELEASING_RRC_CONNECTION_STATE
Note : SVC
0 : NO_SVC
1 : CS_ONLY
2 : PS_ONLY
3 : CS_PS
AT#LTEDS=?
Test command returns the OK result code.
Reference
- 9.9.3.9 ESM cause of TS24.301
- 5.1.3.2.2 EMM state of TS24.301
- 5.1.3.2.3, 5.1.3.2.4 EMM state EMM-DEREGISTERED & EMM-REGISTERED
sub state of TS24.301
#LTEBW – E-UTRAN bandwidth setting.
AT#LTEBW
=[<E-UTRAN_BND>
,<BW>]
This command can operate bandwidth setting.
Parameters:
<
E-UTRAN_BND
>
-
E-UTRAN BAND set.(3,5)
<BW>
-
BandWidth set
-
Sum of integers each representing a specific E-UTRAN bandwidth:
(default value 63( band 3), 15(band 5))
1 - 1.4MHz bandwidth support
2 - 3MHz bandwidth support
4 - 5MHz bandwidth support
8 - 10MHz bandwidth support
16 - 15MHz bandwidth support
32 - 20MHz bandwidth support
- BAND 3 support BW =1.4, 3, 5, 10, 15, 20MHz
- BAND 5 support BW = 1.4, 3, 5, 10MHz
AT#LTEBW?
Read command returns the current parameter settings for
#
LTEBW
command
for all bands in the format:
#LTEBW: <BAND>,<BW>
Summary of Contents for LE910-SKG
Page 1: ......