Telit Wireless Solutions LE910-SKG, At Commands Reference Manual

Page: 247 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 247 of 273
#STGI - SIM Tookit Get Information
0..255 - used as a bit field:
bit 1 :
0 - no selection preference
1 - selection using soft key preferred
bit 2 to 7 :
0
bit 8 :
0 - no help information available
1 - help information available
<numOfItems> - number of items in the list
<titleText> - string giving menu title
<itemId> - item identifier
1.. <numOfItems>
<itemText> - title of item
<nextActionId> - the next proactive command type to be issued upon execution of
the menu item.
0 - no next action information available.
Note: upon receiving the
#STGI response, the TA must send #STSR command (see
below) to confirm the execution of the proactive command and provide any
required user response, e.g. selected menu item.
AT#STGI? The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STGI: <state>,cmdType>
where:
<state> - SAT interface state (see #STIA)
<cmdType> - ongoing proactive command
An error message will be returned if there is no pending command.
AT#STGI=? Test command returns the range for the parameters <state> and <cmdType> .
Note The unsolicited notification sent to the user:
#STN: 37
is an indication that the main menu of the SIM Application has been sent to the TA.
It will be stored by the TA so that it can be displayed later at any time by issuing an
AT#STGI=37 command.
A typical SAT session on AT interface starts after an #STN: 37 unsolicited code is
received, if enabled. At that point usually an AT#STGI=37 command is issued, and
after the SAT main menu has been displayed on TE an AT#STSR=37,0,x
command is issued to select an item in the menu (see below). The session usually
ends with a SIM action like sending an SMS, or starting a call. After this, to restart
the session from the beginning going back to SAT main menu it is usually required
an
AT#STSR=37,16 command.