LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 249 of 273
#STSR - SIM Tookit Send Response
Note:
Use of icons is not supported. All icon related actions will respond with no icon
available.
AT#STSR?
The read command can be used to request the currently ongoing
proactive
command
and the SAT state in the format
#STSR: <state>,<cmdType>
where:
<state>
- SAT interface state (see
#STIA)
<cmdType>
- ongoing proactive command
An error message will be returned if there is no pending command.
AT#STSR=?
Test command returns the range for the parameters
<state>
and
<cmdType>
.
#SMSATRUN – Enable SMS AT Run service
AT#SMSATRUN=
<mod>
Set command enables/disables the SMS AT RUN service.
Parameter:
< mod >
0: Service Disabled
1: Service Enabled
Note: the current settings are stored in NVM.
AT#SMSATRUN?
Read command returns the current settings of <mode> and the value of <stat> in
the format:
# SMSATRUN: <mod>,<stat>
where:
<stat>
- service status
0 – not active
1 - active
AT#SMSATRUN =?
Test command returns the supported values for the SMSATRUN parameters
Notes:
By default the SMS ATRUN service is disabled
It can be activated either by the command AT#SMSATRUN or
receiving a special SMS that can be sent from a Telit server.
Summary of Contents for LE910-SKG
Page 1: ......
