Telit Wireless Solutions LE910-SKG, At Commands Reference Manual

Page: 136 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 136 of 273
+CMSS - Send Message From Storage
+CMGW: 28
AT+CMSS=28
+CMSS: 136
OK
Reference 3GPP TS 27.005
+CMGW - Write Message To Memory
(PDU Mode)
AT+CMGW=
<length>
[,<stat>]
(PDU Mode)
Execution command writes in the <memw> memory storage a new message.
Parameter:
<length> - length in bytes of the PDU to be written.
7..164
<stat> - message status.
0 - new message
1 - read message
2 - stored message not yet sent (default)
3 - stored message already sent
The device responds to the command with the prompt '>' and waits for the
specified number of bytes.
To write the message issue
Ctrl-Z char ( 0x1A hex).
To exit without writing the message issue ESC char ( 0x1B hex).
If message is successfully written in the memory, then the result is sent in the
format:
+CMGW: <index>
where:
<index> - message location index in the memory <memw> .
If message storing fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command execution, no other
SIM interacting commands are issued.
(Text Mode)
AT+CMGW[=<da>
[,<toda>
[,<stat>]]]
(Text Mode)
Execution command writes in the <memw> memory storage a new message.
Parameters:
<da> - destination address, string type represented in the currently selected
character set (see +CSCS).
<toda> - type of destination address.