LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 197 of 273
#SSENDUDP – send UDP data to a specific remote host
a reponse:
AT#SSENDUDP=1,<RemIP2>,<RemPort2>
>response to second host
OK
#SSENDUDPEXT – send UDP data to a specific remote host extended
AT#SSENDUDPEXT
=<connId>,<bytestose
nd>,<remoteIP>,<re
motePort>
This command permits, while the module is in command mode, to send data over
UDP to a specific remote host
including all possible octets(from 0x00 to 0xFF)
As indicated about
#SSENDUDP
:
UDP socket has to be previously opened through
#SLUDP
/
#SA
, then we are able
to send data to different remote hosts
Like
#SSENDEXT
, the device responds with the prompt ‘> ‘ and waits for the data
to send, operation is automatically completed when
<bytestosend>
have been sent.
Parameters:
<connId>
- socket connection identifier
1..6
<bytestosend> -
number of bytes to be sent
1-1500
<remoteIP>
- IP address of the remote host in dotted decimal notation, string type:
“xxx.xxx.xxx.xxx”
<remotePort>
- remote host port
1..65535
AT#SSENDUDPEXT
=?
Test command reports the supported range of values for parameters
<connId>
,
<bytestosend>
,
<remoteIP>
and
<remotePort>
#SGACTAUTH – Easy GPRS Authentication Type
AT#SGACTAUTH=
<type>
Set command sets the authentication type for EPS
This command has effect on the authentication mode used on AT#SGACT
or AT#GPRS commands.
Parameter
<type>
0 - no authentication
1 - PAP authentication (factory default)
2 - CHAP authentication
Summary of Contents for LE910-SKG
Page 1: ......
